By How much is an inducer motor for a Carrier furnace?
The average cost of a Carrier inducer motor replacement is between $800-$1800.
What are the symptoms of a bad inducer motor?
A failing inducer motor may create a noise shortly after a heating cycle begins. This could be a tapping noise, or a humming or whirring sound. If the unit will turn on but the blower motor is not turning on, there are a couple of ways to check if the draft inducer motor has gone bad.
How much does it cost to replace a blower motor in a Carrier furnace?
On average, a Carrier blower motor replacement costs $150-$500. If your furnace needs a new squirrel cage fan, also known as a blower wheel, then you can expect to pay a bit more, about $250-$600 total.
What causes an inducer motor to fail?
Most inducer motors failures are simply attributed to the older age of the furnace. In most cases, the internal bearings wear out and since the unit is a sealed unit, there is no way to repair the original motor. Instead the unit is simply replaced with a new one.
What happens if the inducer motor stops working?
Vibrating noises are another sign of a bad inducer motor. If the motor’s wheel becomes unbalanced, it will vibrate as it spins, often colliding with adjacent components. Because the inducer motor helps your furnace run safely, the furnace will usually shut off if the motor won’t turn on.
What is the purpose of the inducer motor?
The purpose of the inducer motor is to move air and gasses out of the furnace and up through the heating vents. This determines how much and how fast air will flow through the heat exchanger.
How to replace a carrier inducer motor blower wheel?
Carrier Inducer Draft Motor Replacement Part + Link To Installation Instructions Replaces 318984-753, 10704, TJ318984-753, AP5634784, 318984753, 323435-730, 321373-712, 321373712, HC21ZE114A and More! CE LA11AA005 Draft Inducer Blower Wheel, 28 Blades, CW Rot, 0.31″ Bore, 4″ Outside Diameter, 1.5″ Width
Do you need Allen wrench to replace carrier inducer fan?
The size of the new fan matched perfectly to my 25 year Carrier fan. Installation was easy. Three things to keep in mind when installing the new fan. As others have stated, you will need a 3mm Allen wrench. Luckily, my neighbor had one. Secondly, make sure the flat part of the inducer motor shaft is lined up to the set screw.
How big is a draft inducer blower wheel?
CE LA11AA005 Draft Inducer Blower Wheel, 28 Blades, CW Rot, 0.31″ Bore, 4″ Outside Diameter, 1.5″ Width Amazon Business: Make the most of your Amazon Business account with exclusive tools and savings. Login now Amazon Business : For business-only pricing, quantity discounts and FREE Shipping. Register a free business account . . . .
What kind of wrench do I need to replace carrier blower wheel?
The original uses standard allen screw to remove the set screw, this one requires metric 3mm allen wrench for the set screw, which means, if you don’t have one, you will need to go buy it. It was easy to remove the old inducer blower wheel by putting some blow torch heat to the shaft of the bad motor and set screw area.