By How do you fix code P1345?
Loose the distributor hold down bolt with engine OFF. Make sure your OBD scanner is plugged in to monitor the Cam Retard Offset reading. Turn the engine on, let it warm to normal operating temps, and get the rpm’s above 1,000. If your reading is negative, turn the distributor counterclockwise.
What does Engine code P1345 mean?
Error Code P1345 is defined as Crankshaft Position-Camshaft Position Correlation. This error code is a manufacturer-specific trouble code, meaning it does not apply to all vehicles makes. Rather, it applies only to specific vehicle makes, such as Audi, GM (Chevrolet/GMC), Isuzu, Lexus, Mazda, Toyota, and Volkswagen.
What happens if you don’t do a crank relearn?
Failure to do such will result in over revving of the engine, causing possible engine damage. 8. Once the engine has returned to idle, check the status of Diagnostic trouble code P1336. If the scanner indicates that the CASE has been learned, the relearn procedure is now complete.
Why am I getting fault code of p1345 crankshaft position ( CKP )?
I erase … read more 1999 s10 4.3 vortech code reading (p1345). the Haynes manual reads crankshaft position (ckp) or camshaft position (cmp)correlation. I replaced both sensors, cleared the codes and they came back immediat … read more
What does p1345 stand for in GM code?
NOTE: Note that code P1345 with the definition “Crankshaft Position (CKP)-Camshaft Position (CMP) Correlation”, is also used by closely related GM products, including Buick, Cadillac, Chevrolet, Isuzu, Pontiac, and Saturn.
What causes p1345 on a camshaft position sensor?
On these applications, excessive wear of the drive gears, or incorrect installation of the distributor are both roughly analogous to defective camshaft position sensors on applications that use distributor-less ignition systems. Nonetheless, some common causes of code P1345 could include the following-
What’s the p1345 fault code on my Suburban?
Check engine light 1996 Chevrolet Suburban, 5.7 350 engine. Check engine light comes on and with code reader is PO300 (random misfire detected) and code P1345 (camshaft to crankshaft position correlation fault). I erase … read more