How do I connect to EZCloud?

How do I connect to EZCloud?

Go to the Web interface of your device and click Setup > Network > EZCloud. Make sure EZCloud is enabled and the device status is online. If the device status is displayed as Online, the device is connected to the EZCloud server; if displayed as Offline, the device is disconnected from the EZCloud server.

How do I use EZCloud?

1. Scan the QR code at Web interface of the device (Setup > Network > EZCloud, may vary with device or version).
2. Scan the QR code on the device or at Setup > Network > EZCloud in the Web interface.
3. The register code is displayed on the device’s Web interface (Setup > Network > EZCloud) (also on NVR’s local interface).

How do I configure my Uniview IP camera?

Use Guard Tool software from our website to locate the camera on a network. Once the camera address is found the button in the row can be clicked to open the camera in Internet Explorer. The default login is Username: admin and Password: 123456. Once logged into the camera go to “Setup” at the top of the screen.

How do I reset my Uniview camera?

Uniview

1. Use a toothpick or clip to press and hold the RST button at the bottom for about 15 seconds / until the PWR LED turns red.
2. The RST button only works within ten minutes after the camera is powered on.
3. The camera is restored to default settings after the startup.

How do I access UniView remotely?

If you want to access the UniView camera remotely, you need to enable port mapping. “Setup -> Network -> Port Mapping”, “Port mapping” is “Enable”, “Mapping type” is “Manual”.

How do I connect my UniView camera?

How do I connect my Uniview camera?

How do I find the IP address of my UNV camera?

The default static IP address of the camera is 192.168. 1.13, and the default subnet mask is 255.255. 255.0. DHCP is turned on by default.