By How do I fix Error 50 on Brother printer?
Open the clear jam cover on the back of the machine. Look within for traces of foreign objects or jammed paper. Get rid of them and close the jam cover and the scanner cover. If “Unable to print 50” is displayed again, then unplug the machine from the power outlet for 1 minute, then plug it back again.
How do I connect my Brother DCP j140w printer to WIFI?
Press the Up or Down arrow key to select the following:
- Select Network. Press OK.
- Select WLAN. Press OK. (This step might be skipped in some models.)
- Select Setup Wizard. Press OK.
How do I get my Brother printer out of error mode?
You can do it in a few simple steps by unplugging the power cord from the wall outlet and then again switching it on. You can update or re-install the printer driver. According to many Brother Printer users, the Error State is often caused by the corrupting of the printer drivers. The technicians also suggest the same.
Why does my Brother printer keep saying error?
Difficulty printing from your PC can occur for various reasons. The most common reason a networked Brother machine may stop printing, is because the connection between the computer and the Brother machine is lost. This can occur as a result of wrong settings or configuration of the printer driver.
How do I get my printer out of an error state?
Sometimes, simply restarting both your computer and printer can be the solution to the “printer in error state” issue. Power off your printer and computer completely, leaving them in this state for a few minutes, then turn them on again to see if the problem is gone.
How do I clear the error code on my HP printer?
To temporarily clear the error, reset the printer.
- With the printer turned on, disconnect the power cord from the printer.
- Unplug the power cord from the power source.
- Wait 60 seconds.
- Reconnect the power cord to a wall outlet and to the printer. note: HP recommends plugging the printer directly into a wall outlet.