Does flashing go under or over shingles?

Instead of installing the step flashing between shingles, the flashing rests on top of the shingles. It’s not unusual to see sealant installed when sidewall flashing is missing. Sealant will eventually dry, shrink and crack. You’ll see sealant substituted for flashing in a lot of different areas on roofs.

Should there be a gap between roof and wall?

All spaces between your roof and walls must be properly sealed. Small gaps between your exterior wall and roof overhang could cause problems as time goes on. Your roof overhang should extend at least 3/4 to 1 inch beyond your roof to keep water from running inside your walls.

What is roof to wall flashing?

Roof flashing is a thin metal material that roofers install to direct water away from certain areas (walls, chimneys, roof valleys) of your roof. It’s a crucial roofing material that every roof needs to have.

Is roof flashing necessary?

Roof flashing, usually made from metals like aluminum, copper, or steel, is flat and thin, and prevents water from getting under shingles. All of these areas leave shingles and underlayment vulnerable to water, so the flashing is necessary to prevent leaks.

Can you install step flashing on existing roof?

Flashing is generally installed at any joints or edges in the roof where water could otherwise work its way in. In order to properly install new flashing, you’ll have to remove the shingles surrounding your old flashing, and then re-lay them after installation.

Can you install step flashing over shingles?

Install a piece of step flashing over each shingle in a weave fashion. Each piece of step flashing laps over the shingle below and under the shingle above. The bottom edge of the flashing should extend just below the nail line.

How do you fix a gap between a wall and a roof?

Silicone construction caulk will seal exterior building materials, such as brick, stone and metal. Completely fill all visible gaps with caulk and dry with a cloth. You can place strips of foam board insulation on the inside of your attic to keep moisture from coming in openings between your wall and roof overhang.

How do I seal the gaps in my roof?

Slowly move down the joint to apply a steady bead of caulk into the gap. Caulk about 2 feet of the joint and stop to smooth the bead with your finger. Apply more caulk to the gap as needed to fill it completely. Continue caulking until the entire fascia board has been sealed.

Do roofers replace flashing?

Effective Flashing To stop water from leaking into your home, roofers should install metal flashing around vent pipes, chimneys and similar protrusions.